Your shopping cart is empty!
When attaching this Interface, please use proper personal grounding (or grounding wrist strap) to prevent static damage to the module.
The RHP-BOS-CL-SY-IF Camera Link module is an expansion board for the FLIR Boson camera that can connect USB power and communication, analog video, and digital data via Camera Link connection. The Camera Link module takes CMOS-type digital data from the FLIR Boson camera and converts it to Camera Link.
With External Sync Master mode, a Boson camera sends output pulses that indicate to external equipment when frame data acquisition has begun. This output will be at approximately 60 Hz.
With External Sync Master mode, a Boson camera sends output pulses that indicate to external equipment when frame data acquisition has begun. This output will be at approximately 60 Hz.
When the External Sync State is in Slave mode, external equipment sends reference pulses to the Boson camera which begin the acquisition of each video frame by the Boson camera. The input signal rate ideally matches the nominal video acquisition rate of the Boson camera.
The use of external sync on these cameras is not supported because pulses cannot be correlated to a specific output frame because of the way the reduced frame rate video is created. If attempted, the camera will reject commands to begin external sync mode.
It is also possible to enable master/slave sync communication with the RHP-BOS-CL-SY-IF Camera Link module.
The Master/Slave Sync Option allows the Boson to be connected in parallel with a 3.3v buffered port.
The BOS-CL-SY-IF’s microcontroller circuit provides a 3.3V TTL/UART (Universal Asynchronous Receiver/Transmitter) Control to transmit and receive serial data.
Our development team works hard to create functional and practical products with implementation.
The BOS-CL-SY-IF design allows it to be mounted to the FLIR Boson Tripod Bracket. which provisions for standard 1/4" x 20 tripod mounting.
The footprint of the tripod bracket can easily be adapted for custom mounting use.
The camera uses serial communication at 921600 Baud by creating a virtual COM Port on your computer for USB communications.
The BOS-CL-SY-IF USB Video and Control can be performed through the FLIR Camera Controller Graphical User Interface (GUI) , which enables remote command and control of Boson.
With the intelligent polarity sensing protection, the RHP-BOS-CL-SY-IF can be powered in multiple ways:
ENVIRONMENTAL | |
Operating Temperature Range | -40°C to 80°C |
INFORMATION | |
What's In The Box |
The FLIR Boson requires at least one interface board to allow Power and acquire Video from it's high-density connector.
The most popular board in our product list is the Low Profile VPC module. It allows for power input, streaming USB and composite analog video as well as controlling the cameras settings.
A complete list of accessories are available at: https://www.oemcameras.com/boson_accessories.
For video acquisition and control you will need to use the Boson Controller GUI 3.0 available from Teledyne FLIR.
With the RHP Boson interface boards, you may also use the RHP Boson GUI.
If the USB Sensor in the Teledyne FLIR Boson is not triggered (on startup) with the proper voltage for USB-3, it will default to USB-2.
There are three ways to correct this.